Carpet Cleaning - Bissell READYCLEAN 47B2 SERIE Guia Del Usuario

Operations
fill the tank
1. Remove the solution tank by lifting it straight
up, then away from the lower body.
2. Unscrew the black cap at the bottom of the
solution tank.
3. Fill with hot (not boiling) tap water
(140°F/60°C MAX) to the WATeR line. Fill the
rest of the tank with bissell 2X Formula to the
FORMUlA line. Replace and tighten the black cap.
caution: Do not microwave or boil water
before filling.
4. Place solution tank on lower body.

carpet cleaning

1. Plug into proper outlet.
2. Adjust the retractable handle by turning
counterclockwise and lifting the handle up.
Turn clockwise to secure.
3. With foot, press the red power button,
located on the back of the machine.
notE: Handle must be in the full upright
position before cleaning.
4. With foot, press the grey recline lever.
located next to power button.
5. Cleaning strokes. While pressing the
trigger, make one slow forward wet pass and
another one back.
6. Release the trigger and make one slow
forward and backward pass over the same
area.
7. Repeat steps 5 and 6 until solution being
pulled up appears clean.
8. empty the collection tank when dirty water
reaches the full line, or when the solution tank
is empty.
Empty the collection tank
1. With foot, press the red power button, to turn
off and unplug power cord from outlet.
2. Remove the collection tank from base of unit.
a. Release collection tank latches (on each
side) by pulling up from the bottom of latch
and then out.
b. Carefully remove tank by lifting up on the
tank handle.
3. Carry collection tank to a toilet or sink. To
empty, pour out contents using opening at back
of tank.
4. Rinse collection tank thoroughly and replace
on unit.
5. Refill solution tank and continue cleaning.
www.bissell.com
6
Caution: Do not overwet.
800.237.7691
1.
3.
2.
Recline
2a.
3.
2.
4.
3.
Power
4.
2b.