Transfer Units - RK Rose+Krieger E 18 Instrucciones De Montaje

7. Working life

7.2.5 Transfer units

Linear units or drives arranged in parallel or at a right angle must be matched to the transfer shaft
to transfer torques. These are installed using clamped bevel gear housings. The pins on the linear
units and the transfer shaft are fitted straight-toothed with bevel gears. When using bevel gear
drives, only units with ball bearings should be used.
•
fix unstressed to the base
•
Observe the plug-in depth at the bevel gear housings
•
Tighten clamping bolts (DIN EN ISO 4762 8.8) as instructed
Version
RK pipe system linear unit E
RK pipe system linear unit AE
RK pipe system linear unit A
RK pipe system linear unit AS
Electrical unit
48
Plug-in depth at bevel gear housing
43 mm
55 mm
68 mm
80 mm
Electrical unit
DIN EN ISO 4762 8.8
Bevel gear
Transfer unit
Bevel gear housing