Installation Advice; Hydraulic Installation - Ravelli HIDRO LINE HR100 Manual De Uso Y Mantenimiento

Fig.9
T joint for condensate
Installation with horizontal tube
Fig. 9
I
Fig. 4
It is absolutely forbidden to use a mesh at the end of the discharge tube, which
could case poor functioning of the stove. It is compulsory to use watertight
tubing with silicone seals.

6.3. Hydraulic installation

6.3.1. Safety devices for open tank system
6.3.2. Safety devices for closed tank system
Circulator command thermostat
Circulation system
least be 1.5 bar.
Pag.24
Flue inspection

6.3.3. Installation advice

possible to connect the hydraulic system.
Our stoves are equipped with a 6 litre e pansion tank (HR100 - HRV120 -
HRV170) and an 8 litre e pansion tank (HRV160 - HR200).
Fig.10-A
!
FILLING MUST BE CARRIED OUT USING A "T" JOINT PLA-
CED ON THE HEATING SUPPLY, LOADING TO A MAXIMUM OF
1.2 BAR ITH COLD
Fig.11
-
Fig.12-B HRV160 / HR200
Radiators return
3/4 inches
Safety discharge
Radiators discharge
Fig.12-A HR100 / HRV120
Radiators return
Safety discharge
Radiators discharge
6.3.4. Examples of hydraulic installation
Legend
-
-
-
Fig.10-B
ATER (SEE FIG. BELO ).
Correctly connect the boiler con-
2
has not yet been switched on (in
proceed to bleed the hydraulic sys-
Fig.12-C HRV170
Radiators return
Radiators discharge
While bleeding the boiler, ensure
the electrical parts near the valve
are not wet!
In the event this occurs, do not turn
on the boiler, but proceed to dry the
3/4 inches
electronic board using a hairdryer.
M
-
3/4 inches
Safety discharge