Descargar Imprimir esta página

Manual Programming - Schell VITUS VW-E-T Instrucciones De Montaje

Publicidad

Manual programming

1
2
F1
F2
F3
**
Factory setting
** Programming example
Programming is carried out in four steps, which are briefl y
summarised here.
Start manual programming
1.
Disconnect the power supply — wait at least 20 s
— and reconnect the power supply.
When the electronics are booting, the LED in the
sensor fi eld fl ashes red/yellow.
Do not put your hands into the sensor area du-
ring this phase!
Afterwards the LED is red for max. 7 s. During this
red phase, cover the sensor area and keep it co-
vered. Programming mode is started.
Select function (F1 - F3)
2.
The functions are now indicated one at a time by
the fl ashing yellow LED (see table).
To select a function, uncover the sensor fi eld when
the corresponding code is fl ashing.
24
3
Parameters
4 s
:
Flow time
(P1 - P12)
1x
Parameters
:
Stagnation fl ush
Cleaning stop
In the pictures on pages 27 to 29, manual programming is depicted
step-by-step.
As an example it is shown how to set the „Stagnation fl ush" function
(F2) to „On, 24 h after last use" (P2).
Manual programming
Operating elements for programming:
1 Sensor fi eld
2 LED (yellow / red)
3 Sensor area
The following table provides an overview of the main
programs and the available parameters for program-
ming the fi tting manually:
6 s
8 s * 10 s
15 s
20 s
2x
3x
4x
5x
6x
P1
On, 24 h after last
Off *
use **
Off *
On, 60 s
Set parameters
3.
The fl ashing red LED shows you the currently set
parameter (see table).
By covering the sensor area again you can set the
corresponding parameter. The parameters are in-
dicated one at a time by the fl ashing red LED (see
table).
To set a parameter, uncover the sensor area when
the corresponding code is fl ashing.
Start operation
4.
After leaving the sensor fi eld, the programming
mode starts once again with a time window of 7
seconds (red LED is on continuously).
If the sensor fi eld is not covered during these 7
seconds, the programming is completed. The fi tting
is now ready for use.
30 s
40 s
60 s
120 s
7x
8x
9x
10x
P2
P3
On, daily
every 24 h
180 s
240 s
11x
12x

Publicidad

loading

Este manual también es adecuado para:

Vitus vw-e-t mit be-f