Lcd Setting - Phasak PH 9273 Manual De Uso

3.7. LCD Setting

Parameter 1
Parameter 2 Parameter 3
Programs available list for parameter 1:
Code
01
Output voltage
Output Frequency
02
03 Voltage range for bypass
04 Frequency range for bypass
05 ECO mode enable/disable
06 Voltage range for ECO mode
07 ECO mode frequency range setting
08 Bypass mode setting
09 Maximum battery discharge time
10 Reserved
Reserved
11
12 Neutral loss detection
13 Battery voltage calibration
14 Charger voltage adjustment
15 Inverter A voltage adjustment
16 Inverter B voltage adjustment
17 Inverter C voltage adjustment
18 Output A voltage calibration
19 Charger voltage adjustment
20 Inverter voltage adjustment
*Y means that this program can be set in this mode.
Note: All parameter settings will be saved only when UPS shuts down normally with internal or external battery connection. (Normal UPS
shutdown means turning off input breaker in bypass/no output mode).
Segurança e harmonia
ININTERRUPTA
There are three parameters to set up the UPS.
Parameter 1: It's for program alternatives.
There are 20 programs to set up. Refer to the table.
Parameter 2 and parameter 3 are the setting options or values for each
program.
Note: The following order of setting code only presents when UPS is in
Bypass Mode or no-output mode. The setting code number will change
the numbers under other modes. For example, when the UPS is in AC
mode, the total available setting becomes 10 only. Then, setting code of
"Bypass mode setting" will become 01, "Battery backup time setting" will
become 02, and so on.
Description Bypass AC ECO
Y *
Y
Y
Y
Y
Y
Y
Y Y
Y Y Y
Reserved for future options
Reserved for future options
Y Y Y
Y Y Y
Y Y Y
Y
Y
Y
Y
Y
Y
Uninterruptable Power Supply
3. Operations
Battery
CVCF Battery
test
Y Y Y
Y Y Y
Y Y Y
Y Y Y
Y Y
Y Y
Y
Y
Y Y
Y Y
Y Y
PH 9273 | PH 9293
EN
75