Functions Of Rotary Switch Description; Dc Voltage Measurement - HT HT4010 Manual De Instrucciones

4.3 FUNCTIONS OF ROTARY SWITCH DESCRIPTION

4.3.1 DC Voltage measurement

1. Rotate the switch on V
2. Pressing the RANGE key to select the correct range or using the Autorange feature
(see paragraph 4.2.3). If the voltage value under test is unknown, select the highest
range
3. Insert the red test lead plug into VΩ
jack
4. Connect the two long ends of test leads to the desired circuit (see Fig. 2) then reading
will be displayed
5. "OL" message is shown at display if the DC voltage under test is over the maximum
value that the instrument is able to measure
6. The "-" symbol at display means that the voltage have an opposite sign respect the
connection of Fig. 2)
7. For HOLD and MAX features please refer to paragraph 4.2
1.800.561.8187
Maximum input for AC Voltage measurements is 600VDC or 600VACrms.
Do not take any voltage measurement exceeding this limit in order not to
risk electrical shock or damaging the meter.
Fig. 2: Taking DC voltage measurement
position. The "DC" symbol is shown at display
www.
CAUTION
jack and the black test lead plug into COM
information@itm.com
.com
EN - 9
HT4010