Preparation For Use; Initial; Power Supply; Calibration - HT HT4010 Manual De Instrucciones

HT4010

3 PREPARATION FOR USE

3.1 INITIAL

The tester has been checked from a mechanical and electrical point of view before
shipment.
Every care has been taken to make sure that the instrument reaches you in perfect
conditions.
However, it's advisable to make a rapid check in order to detect eventual damages which
may have occurred in transit. Should this be the case, enter immediately the usual claims
with the carrier.
Make sure that all the accessories listed in paragraph 6.3.1 are contained in the package.
In case of discrepancies contact the dealer.
In case of returning of the tester please keep to the instructions given in paragraph 7.

3.2 POWER SUPPLY

The instrument is battery supplied. One battery 9V IEC 1604 NEDA 6F22 are included in
the package. When battery is low, the symbol "BAT" appears on the display. Replace it
immediately, following the instructions given in paragraph 5.2.

3.3 CALIBRATION

The tester complies with the technical features listed in this manual. Its performances are
guaranteed for one year.

3.4 STORAGE

In order to guarantee the accuracy of the measurements, after a period of storage in
extreme environmental condition, wait for the necessary time so that the tester returns to
normal measuring conditions (see environmental specifications, paragraph 6.2.1).
1.800.561.8187 information@itm.com
www. .com
EN - 6