Electrical Connections - Erreka VIVO-D201 Manual Del Instalador

4

ELECTRICAL CONNECTIONS

 Complete the installation in line with low voltage regulations and applicable rules.

Use cables with sufficient section, always earthed.

Check the manufacturer's instructions for all the elements installed.
Power supply and operator connections

This control board has been designed and
constructed to be connected to 24 Vdc operators of
different models:
• operators with encoder (C701): BUL (C301), TOPO
(C302), ARC 24V (C303), AXIL 24V (C305)
• operators without encoder or limit switches (C700):
ARES 24V (C304)
• operators with limit switches (C702)
• operators with duel encoder (C703)
• operators with encoder and limit switches (C704)
Operator connection with encoder and without limit switches, C701
GND
SNG1
V+
ENCODER1
P13 P14 P15 P16 P17 P18 P19 P20 P21 P22 P23
P1 P2 P3
A1
Operator 1
A2
Operator 2
G1/G4 Red cable (motor)
G2/G5 Blue cable (motor)
V+
Brown cable (encoder
supply)
GND
Mesh (encoder mass)
SNG1 Green cable (encoder
signal 1)
SW1
Main switch
(BUL, TOPO, ARC 24V, AXIL 24V)
P24 P25
ENCODER2
-FT
AUX
(Test)
24 Vdc
P4 P5 P6 P7 P8 P9 P10 P11 P12

Select the number of operators using C0
(C001: one operator, C002: two operators).

Select the directions using C1 (A1) and C2 (A2).

Programme the parameter C7 for operation with encoder: C701.

Select the type of encoder using C3 (C301: BUL, C302: TOPO,
C303: ARC 24V, C305: AXIL 24V).
O
These operators do not require capacitors for
operation.

The control board
programmed in accordance with the operator
used. If not programmed correctly, the facility
may operate incorrectly, with the risk of
accidents and failures. If in doubt, check with
an ERREKA agent.
MOTOR2 SW1
G4 G5 G6
MOTOR1
G7 G8
G1 G2 G3
INSTALLATION
must be properly
G9 G10
N L
POWER - 230V
VIVO-D201:
VIVO-D201M:
P144Y1
VIVO-D201 Control board
53