Failure Diagnosis; Scrap - Erreka VIVO-D201 Manual Del Instalador

MAINTENANCE AND DIAGNOSIS OF FAILURES
4

FAILURE DIAGNOSIS


The F1, F2 and F3 fuses are shown in the diagram of the page 55.
Problem
The gate does not make
any movement when a
key command is given
The gate does not move
(see the Note A)
The gate does not detect
the stoppers
(see the Note A)
The gate does not open
(the display shows C4 or
C5)
The gate does not open
(the display shows C9)
The gate
completely close
open)
Note A This control board has been optimised for the operators BUL, TOPO, ARC 24V, ARES 24V and AXIL 24V. For the
other operators which can be used, the installer must carry out the corresponding adjustments in order to
obtain optimum operation.
5

SCRAP

 The device, up until the end of its useful life,
must be dismounted at its location by an
installer who is as well qualified as the person
who completed the assembly, observing the
same precautions and safety measures. In this
manner possible accidents and damage to
adjacent facilities will be avoided.
66
Installation Manual
Cause
Absence of system power supply voltage
F1, F2 or F3 blown
Emergency shutdown button open (the
display shows StOP)
Command devices defective
The transmitter is not programmed in the
control board
The transmitter batteries are flat
You have programmed too high a speed for a
low thrust value
You have programmed too high a thrust value
for a low speed value
The interior or exterior safety device (photocells)
or its cabling is open or defective
Fuses F2 or F3 blown
The safety strip or its cabling is open or defective
The safety device detects an obstacle
cannot
The operator thrust is too low (the display
(or
shows F1 or F2)
Run not programmed correctly
Solution
Reestablish the power supply
Replace using another fuse of the
same value and investigate the cause
of the failure
C h e c k t h e p u s h b u t t o n a n d t h e
cabling
Check the respective manuals
Programme the transmitter correctly
Replace the batteries
Correctly programme the speed
( p a r a m e t e r A 3 ) a n d t h e t h r u s t
(parameter A6). See the Note A.
Correctly programme the thrust
( p a r a m e t e r A 6 ) a n d t h e s p e e d
(parameter A3). See the Note A.
Check the cabling and the device
(photocells)
Replace using another fuse of the
same value and investigate the cause
of the failure
Check the cabling and the safety strip
Remove the obstacle and try again
Correctly programme the operator
thrust (A6)
Programme again
}
The device must be deposited in the appropriate
containers for subsequent recycling, separating and
classifying of the different materials in line with their
nature. NEVER deposit it in domestic rubbish or in
landfills which are not suitably controlled, as this will
cause environmental contamination.