Hitachi WH 18DBDL Manual De Instrucciones página 15

NOTE:
Do not give a strong shock to the switch panel or
break it.It may lead to a trouble.
To save the battery power consumption, the
remaining battery indicator lamp lights while
pressing the remaining battery indicator switch.
11. How to use the LED light
Every time you press the light switch on the switch
panel, the LED light lights or goes off. (Fig. 12)
To prevent the battery power consumption, turn off
the LED light frequently.
Light switch
CAUTION
Do not expose directly your eye to the light by
looking into the light.
If your eye is continuously exposed to the light,
your eye will be hurt.
NOTE:
To prevent the battery power consumption caused
by forgetting to turn off the LED light, the light goes
off automatically in about 15 minutes.
12. Tightening mode selector function (Fig. 13)
CAUTION
Do not subject the switch panel to shock or
damage.
Select high/low mode and single/continuous
mode while the trigger switch is released. Failure
to do so could result in malfunction.
Fig. 12
(1) High/Low selector switch
The rotation speed changes in 4 steps (900 1,400
2,000 2,600/min) each time the high/low selector
switch is pressed.
(2) Single/Continuous selector switch
The tightening torque can be adjusted according to
the work by changing the tightening mode using the
single/continuous selector switch and the high/low
selector switch on the side of the impact driver/
wrench.
When the forward/reverse button is set to reverse,
the high/low mode and single/continuous mode are
set to "High" and "Continuous" respectively,
regardless of the indicators on the switch panel.
The mode switches between single and continuous
mode each time the single/continuous selector
switch is pressed.
In single mode, after the trigger switch has been
pulled to start operation, bolt-tightening stops
automatically after 1 to 4 tightenings.
In continuous mode, when the trigger switch is
pulled to start operation, bolt-tightening continues
(without stopping automatically).
NOTE:
The appropriate mode differs depending on the
screw and the material being screwed. Drive in a
few test screws and adjust the mode setting
accordingly.
The high/low and single/continuous selector
switches can only be set after the battery has been
installed in the impact driver/wrench and the trigger
switch has been pulled once.
English
High/Low Single/
indicator Continuous
lamp indicator lamp
High/Low
Single/
selector
Continuous
switch
selector
switch
Fig. 13
15