Hamilton Beach Revolution Serie Manual De Instrucciones página 8

Operation
Using Automatic Cycles
wWARNING
Electrical Shock Hazard
Plug into a grounded outlet.
Do not remove ground.
Do not use an adapter.
Do not use an extension cord.
Failure to follow these instructions can
result in death, fire, or electrical shock.
About Automatic Cycles
The automatic cycles on the Ice Shaver/Blender
save time and help ensure consistent results. You
select the serving size and the number of servings,
and the unit automatically shaves the appropriate
amount of ice and runs the blender for a preset
time to ensure the proper mixing of ingredients.
Using Automatic Cycles
1. Fill the ice hopper and make sure the ice hopper
cover is properly in place.
2. Place the non-ice ingredients to be blended in
the jar.
3. Make sure the main power switch is in the ON (I)
position.
4. Place the jar onto the base. Make sure it is
securely seated. If the jar is not properly seated,
the jar pad sensors (if enabled) will not allow the
blender to start and an error message will be
displayed when the START button is pressed.
Once the jar is properly seated, the following
standby message should be displayed:
8OZ 12OZ 16OZ 20OZ
HAMILTON BEACH
COMMERCIAL
1DR 2DR 3DR
5. Press the pad (A-D) for the desired serving size.
Your selection will begin flashing.
8
4DR
wWARNING
Cut Hazard
Do not attempt to operate ice shaver without
cover in place.
Do not put place anything except ice in the
ice hopper.
Always make sure splash shield is in place
when blending.
Do not put hands, spoons or other utensils
in jar when blending.
Failure to follow these instructions can
result in broken bones, cuts or other injuries.
6. Press the pad (1-4) for the desired number of
servings.
NOTE: If the selected total quantity (size x
quantity) exceeds the capacity of the container
(64 oz./1.9 L), the following message will appear:
CONTAINER CAPACITY
EXCEEDED
Select a new quantity within 5 seconds to continue;
if a new quantity is not selected within 5 seconds,
the unit will return to standby mode.
7. Once the size and quantity have been selected
and the container is properly in place, press
START.
The Ice Shaver/Blender will begin shaving ice, and
the blender will begin to mix. This ensures proper
mixture of the ice and other ingredients. Once the
proper amount of ice has been shaved into the
blender jar, the ice shaver will stop, while the
blender continues to run until the end of the cycle.
8. Remove the jar to serve.
9. Clean the jar as directed in "Care and Cleaning."