Replacement Parts - Hamilton Beach Revolution Serie Manual De Instrucciones

Maintenance
Inspect the blender and its various parts and replace as follows:
Daily Unplug the unit and remove the container from the base, and then inspect the container
and cutter unit assembly for wear, nicks, and broken or loose blades. Replace if necessary.
If the blades are loose, discontinue use immediately and replace the blades.
See "Replacement Parts" below.
Weekly Unplug the unit, and then inspect the power cord insulation and power plug for cracks.
Refer to "Requesting Assistance or Service" for repair or replacement.
Quarterly Replace the container and cutter assembly at least every 90 days.
See "Replacement Parts" below.

Replacement Parts

Refer to "Technical Service" to order parts below.
Part Description
64 oz. container
Cutter assembly
Ice shaver blade assembly
Shaver belt
Blender belt
Blender motor brush kit
Blender motor assembly
Chute cover/splash shield
Inner ice hopper
Ice hopper cover
Jar pad
Drive bearing assembly with clutch
Pre-programmed memory card
Container lid with filler cap
Drain hose
Controls panel
Agititator/thumbscrew/O-ring
Shaving pool with chute
Hopper isolation grommets
Main PCBA assembly
Speed/revolution sensor
Leveling foot/jam nut
Belt tensioner assembly
Inner hopper/Hopper lid interlock switch
Caring for the Ice Shaver/Blender
Part Number
6126-1200
961200
SB1200
990028700
990028800
990028900
990029000
990029100
990029200
990029400
990029500
990029600
MC1200
990029800
990029900
990030000
990030200
990030300
990030400
990030500
990030600
990030700
990030800
990030900
15