Filling Solution Tank - Tennant ASC-15 Manual Del Operario

OPERATION
EN

FILLING SOLUTION TANK

1. Remove the front solution tank lid from machine.
Add an approved rinsing agent to the tank according
to dilution instructions on bottle.
ATTENTION: Use of unapproved or inappropriate
chemicals may cause damage to machine and
surfaces and could void your warranty
FOR SAFETY: When using machine, follow
mixing, handling, and disposal instructions
provided on chemical container instructions.
2. Connect fill--hose (supplied with machine) to water
faucet and fill tank with 15 gallons (56 L) of clean
water (Figure 4). If using hot water, do not exceed
140 F / 60 C.
WARNING: Fire or Explosion Hazard. Never
Use Flammable Liquids Or Operate Machine In Or
Near Flammable Liquids, Vapors Or Combustible
Dusts.
FIG. 4
3. Replace solution tank lid after filling.
CONNECTING POWER CORD TO WALL OUTLET
1. Connect power cord into a grounded wall outlet
(Figure 5). Use a wall outlet outside the area to be
cleaned.
Grounded
3 Hole Outlet
Ground Pin
(120V)
FIG. 5
FOR SAFETY: Do not operate machine unless
cord is properly grounded.
8
Grounded Outlet
Grounding
Edge/hole
(220V/230V/240V)
Home Find... Go To..
FOR SAFETY: Do not operate machine with the
use of an extension cord .
2. The power cord is equipped with a Ground Fault
Circuit Interrupter device (Figure 6). The GFCI
protects the user against electrical shock (120V
Models Only).
Test GFCI device before each use.
a. Verify that the indicator is red.
b. Press test button, red indicator should
disappear.
c. Press reset button. If test fails, do not use
machine. Call an authorized service
representative for assistance.
FIG. 6
WARNING: The Ground Fault Circuit
Interrupter (GFCI) does not protect user against
electrical shock due to contact with both circuit
conductors or a fault in any wiring supplying this
device. Do not use extension cord between GFCI
and power outlet.
WARNING: Electrical Hazard. Do Not Operate
With Damaged Power Cord. Do Not Modify Plug.
Unplug power Cord Before Servicing Machine.
If the supply cord is damaged or broken, it must
be replaced by the manufacturer or it's service
agent or a similarly qualified person in order to
avoid a hazard.
ASC- -15 / ASC- -57 (10- -11)