Daily Maintenance - Tennant ASC-15 Manual Del Operario

OPERATION
EN

DAILY MAINTENANCE

(After Every Use)
1. Clean metering tip and flush blue injector tube as
described below:
a. Fill solution tank with 3 gallons / 11 L of clean
water.
b. Remove metering tip from injector tube and
clean tip. Do not use pointed objects such as
pins and paper clips to unplug tips (Figure 37).
FIG. 37
c. Submerge end of injector tube into a gallon
container of clean water (Figure 38).
FIG. 38
d. Adjust spray gun to low pressure by pushing
spray nozzle outward.
e. Turn the FORMULA ON/OFF lever to the ON
position, located at front of machine.
f. Turn pump switch on and operate spray gun
for approximately one minute.
g. Place cap on injector hose after flushing.
16
Home Find... Go To..
2. Drain and rinse recovery tank thoroughly
(Figure 39).
FIG. 39
3. Remove the float shut--off screen from recovery
tank cover and clean (Figure 40).
FIG. 40
4. Empty any leftover water from solution tank if
storing machine for an extended period or if
transporting machine (See DRAINING TANKS).
5. Wipe clean all accessories and replace on
machine. Inspect vacuum hoses for holes and
loose cuffs.
6. Inspect condition of squeegee blades, replace if
necessary.
7. Wipe clean power cord and check for damage.
Replace if necessary. Coil cord neatly after use.
ASC- -15 / ASC- -57 (04- -10)