Xylem Si Analytics ViscoClock Manual De Instrucciones página 25

Observe the safety data sheets of the manufacturers!
• When handling solvents please observe the pertinent memorandums of the employer's liability insurance
associations (VBG 1 and VBG 113).
• When using alkaline Iaboratory cleaners there is a danger to health (caustification, darnage to skin and
eyes)!
Please observe the memorandums of the employer's liabillty insurance associations and the safety data
sheets of the manufacturers.
• When using tampering liquids with a temperature above 50 °c there is a danger of getting burnt when
touching the thermostat bath cover!
• Please observe the standard regulations and Standards for capillary-viscosity measurements.
• You can obtain a list of the national and international standards from SI Analytics GmbH.
2 Unpacking the Viscosity Measuring Unit ViscoClock
• Check packing tor damage. In case of damage contact your supplier.
• Remove the Viscosity Measuring Unit ViscoClock and the TZ 1858 universal voltage power supply from
the packing.
Scope of delivery: Software CD VZ 6555
Universal voltage power supply TZ 1858
Primary adapter for Europe
Primary adapter for USA
Manual pump 'press' VZ 6550
NOTE: The scope of delivery does not include viscometers.
• Place the Viscosity Measuring Unit ViscoClock in a dry environment on a plane surface. Ambient tem-
perature: + 10 °c ... + 40 °c (→ chapter 1.2, technical data).
Owing to the small stand foot and the relatively high center of gravity we recommend storing the Viscosity
Measuring Unit ViscoClock always in a horizontal position outside of the bath.
Properties and range of use 23