Disposal; Manufacturer's Warranty - Tools - Hilti TE 4-A18 Manual De Instrucciones

Ocultar thumbs Ver también para TE 4-A18:
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

Fault
The power tool or the battery
gets very hot.
The insert tool can't be
en
released.
The tool makes no progress.

8 Disposal

CAUTION
Improper disposal of the equipment may have serious consequences: the burning of plastic components generates
toxic fumes which may present a health hazard. Batteries may explode if damaged or exposed to very high
temperatures, causing poisoning, burns, acid burns or environmental pollution. Careless disposal may permit
unauthorized and improper use of the equipment. This may result in serious personal injury, injury to third parties and
pollution of the environment.
CAUTION
Dispose of defective batteries right away. Keep them out of reach of children. Do not disassemble or incinerate the
batteries.
CAUTION
Batteries that have reached the end of their life must be disposed of in accordance with national regulations or returned
to Hilti.
Most of the materials from which Hilti power tools or appliances are manufactured can be recycled. The materials
must be correctly separated before they can be recycled. In many countries, Hilti has already made arrangements for
taking back your old power tools or appliances for recycling. Please ask your Hilti customer service department or
Hilti representative for further information.

9 Manufacturer's warranty - tools

Please contact your local Hilti representative if you have
questions about the warranty conditions.
8
Possible cause
The power tool has been overloaded
(application limits exceeded).
The chuck is not pulled back fully.
The forward/reverse switch is set to
reverse rotation.
The function selector switch is set to
"Drilling without hammering".
Remedy
Use the right power tool for the job
(don't use a low-powered tool for
heavy work).
Pull the chuck back as far as it will go
and remove the insert tool.
Set the forward/reverse switch to for-
ward rotation.
Set the function selector switch to
"Hammer drilling".

Publicidad

Capítulos

Tabla de contenido
loading

Tabla de contenido