Disposal - Hilti TE 30-A36 Manual De Instrucciones

Fault
The power tool doesn't run and
1 LED blinks.
The tool doesn't work and all 4
LEDs blink.
The battery runs down more
quickly than usual.
The battery doesn't engage with
an audible double click.
The control switch can't be
pressed, i.e. the switch is
locked.
The drive spindle doesn't rotate.
The power tool switches itself
off automatically.
The power tool or the battery
gets very warm.
The insert tool can't be
released.
The drill bit makes no progress.

10 Disposal

CAUTION
Improper disposal of the equipment may have serious consequences: the burning of plastic components generates
toxic fumes which may present a health hazard. Batteries may explode if damaged or exposed to very high
temperatures, causing poisoning, burns, acid burns or environmental pollution. Careless disposal may permit
unauthorized and improper use of the equipment. This may result in serious personal injury, injury to third parties and
pollution of the environment.
CAUTION
Dispose of defective batteries without delay. Keep them out of reach of children. Do not attempt to open or dismantle
batteries and do not dispose of them by incineration.
CAUTION
Dispose of the batteries in accordance with national regulations or return them to Hilti.
Possible cause
The battery is discharged.
The battery is too hot or too cold.
The power tool has been overloaded.
The overheating prevention cut-out
has been activated.
Battery condition is not optimal.
The retaining lugs on the battery are
dirty.
The forward / reverse switch is in the
middle position (transport lock en-
gaged).
The permissible operating temper-
ature of the power tool's electronics
has been exceeded.
The permissible battery operating
temperature has been exceeded.
The battery is discharged.
The overload cut-out has been activ-
ated.
Electrical fault.
The power tool has been overloaded
(application limits exceeded).
The chuck is not pulled back fully.
The forward/reverse switch is set to
reverse rotation.
Remedy
Change the battery and recharge the
discharged battery.
Bring the battery to the recommen-
ded working temperature.
Release the control switch and press
it again.
Allow the power tool to cool down.
Clean the ventilation slots.
Have battery condition diagnosed by
Hilti Service or replace with a new
battery.
Clean the retaining lugs and check
that the battery engages securely.
Contact Hilti Service if the problem
persists.
Push the forward / reverse switch to
the left or right.
Allow the power tool to cool down.
Bring the battery to the recommen-
ded working temperature.
Change the battery and recharge the
discharged battery.
Release the control switch, reduce
the load on the power tool and then
press the switch again.
Switch the power tool off immedi-
ately, remove the battery and contact
Hilti Service.
Use the right power tool for the job
(don't use a low-powered tool for
heavy work).
Pull the chuck back as far as it will go
and remove the insert tool.
Set the forward/reverse switch to for-
ward rotation.
en
27