Amprobe TMA-21HW Manual De Uso página 22

Manual Data Memory and Read Mode
TEST ID 1 ~ 4 Memory Mode :
• Push "Test ID" key to select the "TEST ID 1" memory.
• Push "AUTO MEM" key each time, one set of reading to will be stored
to the memory. At this moment, display will show the " M " symbol one
time and the memory address number. Total memory size is 99 sets.
If change to another Flow Set Up setting, the TEST ID will automatically
increment.
• Push "READ" key to enter READ mode, the display will show " R "
symbol and the memory address number. Push "" or "" key to select
the desired memory address number data for display.
• Push "VEL %RH" key to circulate the display of the other reading.
• Push "MX/MN" key to circulated the memory of the maximum (MAX)
air velocity and air flow reading and the memory address number, the
minimum (MIN) air velocity and air flow reading and the memory address
number, and the average (AVG) air velocity and air flow reading and the
total average samples.
• Push "READ" key for 2 second to exit the READ mode.
Auto Data Memory and Read Mode
TEST ID 5 ~ 9 Memory Mode :
• Push "Test ID" key to select the "TEST ID 5" memory.
• Push "AUTO MEM" key to start auto data memory mode, "INTV"
symbol and current interval time are display, when " M " symbol flicks
one time that means one set data has been memorized. Total memory
size is 99 sets per each IDs. Push "AUTO MEM" key again to exit this
mode.
If change to another Flow Set Up setting, the TEST ID will automatically
increment.
• Push "READ" key to enter READ mode, the display will show " R "
symbol and the memory address number. Push "" or "" key to select
the desired memory address number data for display.
• Push "VEL %RH" key to circulate the display of the other reading.
10