Maintenance; Maintenance Recommendations; Maintenance Schedule; Alert System Maintenance - Generac OneWASH Power Washer Manual Del Operador

Figure 31 – on/oFF switch
ON/OFF SWITCH
LOW OIL
LOW WATER
DELICATE
2000 PSI
IMPORTANT: Spray gun traps high water pressure, even when
engine is stopped and water is disconnected.
The high pressure stream of water that this equipment
produces can cut through skin and its underlying
tissues, leading to serious injury and possible
amputation. Spray gun traps high water pressure, even
when engine is stopped and water is disconnected,
which can cause injury.
• Keep high pressure hose connected to pump and spray gun while
system is pressurized.
• ALWAYS point spray gun in safe direction, squeeze spray gun
trigger to release high pressure, every time you stop engine.
Engage trigger lock when not in use.

MAINTeNANCe ReCOMMeNdATIONS

Regular maintenance will improve the performance and extend
the life of the power washer. See any qualified dealer for service.
The power washer's warranty does not cover items that have been
subjected to operator abuse or negligence. To receive full value
from the warranty, the operator must maintain the power washer
as instructed in this manual, including proper storage as detailed
in Winter Storage and Long Term Storage.
Should you have questions about replacing components
on your power washer, please call 1-888-436-3722 for
assistance.
Some adjustments will need to be made periodically to properly
maintain your power washer.
All service and adjustments should be made at least once each
season. Follow the requirements in the Maintenance Schedule
chart.
Once a year you should clean or replace the spark plug, clean
or replace the air filter, and check the spray gun and nozzle
extension assembly for wear. A new spark plug and clean air
filter assure proper fuel-air mixture and help your engine run
better and last longer.
HEAVY DUTY
3100 PSI
NOTe:
NOTe:

MAINTeNANCe SCHedule

Follow the hourly or calendar intervals, whichever occurs first.
More frequent service is required when operating in adverse
conditions.
first 5 Hours
Change engine oil
every 8 Hours or daily
Check/clean water inlet screen*
Check high pressure hose
Check detergent siphoning hose/filter
Check spray gun and assembly for leaks
Clean debris
Check engine oil level
every 20 Hours or every Season
Change engine oil**
every 50 Hours or every Season
Check/clean air cleaner filter**
Inspect muffler and spark arrester*
every 100 Hours or every Season
Service spark plug
* Clean if clogged. Replace if perforated or torn.
** Service more often under dirty or dusty conditions.

AleRT SySTeM MAINTeNANCe

Your alert system is powered by a CR2032 battery. The battery
must be replaced if the indicator light does not work. The fault
indicator light will flash once when recoil rope is pulled to start
your unit. If the fault indicator light remains on and steady the
battery needs to be replaced.
1. Locate the circuit board on back of the control panel (Figure
32).
Figure 32 – Circuit board
Billboard
2. Remove the 2 mounting screws.
3. Remove circuit board from control panel making sure not to
damage the foam seal.

Maintenance

(NOT SUPPLIED)
Screw
Circuit Board
15