Connect Hose And Water Supply To Pump - Generac OneWASH Power Washer Manual Del Operador

Set-up
1. Clean area around fuel fill cap, remove cap.
2. Slowly add regular unleaded fuel to fuel tank. Be careful not
to overfill. Fill to bottom of filter screen, this will allow for fuel
expansion (Figure 10).
3. Install fuel cap and let any spilled fuel evaporate before
starting engine.
Figure 10 – adding Fuel

CONNeCT HOSe ANd WATeR SuPPly TO PuMP

dO NOT run the pump without the water supply connected
and turned on. damage to equipment resulting from failure to
follow this instruction will void warranty.
Remove and discard the shipping cap from the pump's water
inlet before attaching hose.
1. Run water through your garden hose for 30 seconds to clean
out any debris.
2. Before connecting garden hose to water inlet, inspect inlet
screen (A) (Figure 11). Clean screen if it contains debris or
have it replaced if damaged. DO NOT run power washer if inlet
screen is damaged.
IMPORTANT: DO NOT siphon standing water for the water supply.
Use ONLY cold water (less than 100°F). Water supply must be
adequate to handle greater than 3.8 gallons per minute and no less
than 30 psi.
using a One Way Valve (vacuum breaker or check valve) at
pump inlet can cause pump or inlet connector damage.
• There MUST be at least ten feet of unrestricted garden hose
between the power washer inlet and any device, such as a
vacuum breaker or check valve.
• Damage to equipment resulting from failure to follow this
instruction will void warranty.
8
NOTe:
NOTe:
NOTe:
Figure 11 – inspect inlet screen
A
3. Connect the garden hose (not to exceed 50 feet in length) to
the water inlet (Figure 12). Tighten by hand.
Figure 12 – Connect garden hose
Risk of eye injury. Spray can splash back or propel
objects.
• Always wear safety goggles when using this equipment or in
vicinity of equipment in use.
• Before starting the power washer, be sure you are wearing
adequate safety goggles.
• NEVER substitute safety glasses for safety goggles.