Monogram ZDT165SILII Manual Del Propietário página 11

Filter Inspect and clean the filters periodically. This should be done every month or more depending on
usage. If there is a decrease in wash performance or dishes feel gritty, this is also an indication the
Assembly
filters need to be cleaned.
To clean the filter assembly, remove the bottom
rack and lower spray arm. Twist the filter
assembly counterclockwise and lift to remove.
Remove the filter plate.
Rinse the filters with warm soapy water.
Scouring pads or brushes can scratch the filter
surfaces but a soft brush or sponge may be
needed to remove stubborn soils or calcium
deposits caused by hard water.
Once cleaned, replace the filter plate, insert
the filter assembly through the plate and twist it
clockwise until it locks in place. Make sure the
filters are fully seated as improper replacement
of the filters may reduce the performance level
of the appliance. Replace the lower spray arm
and lower rack.
Stainless
The stainless steel used to make the dishwasher
tub and inner door provides the highest reliability
Steel Inner
available in a Monogram dishwasher.
Door & Tub
Protect
If your dishwasher is left in an unheated place during
the winter, ask a service technician to:
Against
Freezing
1 Turn off electrical power to the dishwasher.
Remove fuses or trip circuit breaker.
2 Turn off the water supply and disconnect the
water inlet line from the water valve.
Does Your
An air gap protects your dishwasher against
water backing up into it if a drain clogs. The
Dishwasher
air gap is not a part of the
Have an
dishwasher. It is not covered
Air Gap?
by your warranty. Not all
plumbing codes require air
gaps, so you may not have
one.
Filter Assembly
Lower
Spray Arm
Check the air gap any
time your dishwasher
isn't draining well.
Care and Cleaning
counterclockwise
and lift to remove
Press tabs on
the fine filter
and pull to
separate from
the coarse filter
Filter
Plate
IMPORTANT: Before replacing, make sure no objects have
fallen into the opening in the bottom of the dishwasher.
Replace the filter plate.
Snap the fine filter back
into the coarse filter.
Place filter assembly
through the filter plate
and twist clockwise to
lock into the dishwasher
If the dishwasher tub or inner door should be
scratched or dented during normal use, they will
not rust or corrode. These surface blemishes will
not affect their function or durability.
3 Drain water from the water inlet line and water
valve. (Use a pan to catch the water.)
Reconnect the water inlet line to the water valve.
4
The air gap is easy to clean.
1
Turn off the dishwasher and lift off the air gap
Air gap
cover.
2 Remove the plastic cap under the cover and
clean with a toothpick.
3 Replace the cap and cover when the air gap is
clean.
Dishwasher
Twist
Filter
Plate
Fine Filter
Coarse
Filter
11