Dispensers - Monogram ZDT165SILII Manual Del Propietário

Start Dishwasher
6
START Press the START button and close the door within 4 seconds to start the cycle or begin the
DELAY START countdown. The START light will turn on. The wash cycle will begin after 10
seconds and then pump out for 60 seconds prior to filling the dishwasher with water. To activate
the display, press any button with the door open.
Interrupt To interrupt or pause a cycle, slowly open the door. Opening the door will cause the wash cycle
or Pause to pause. The dishwasher will beep every minute to remind you to close the door. To restart or
resume the cycle, press Start, and close the door within 4 seconds. If the door is not closed within
4 seconds, the START light will start blinking and the dishwasher will beep once every minute to
signal that the cycle did not restart. If the START light is blinking, the dishwasher is waiting for input.
Cancel To cancel a wash cycle, press and hold the START button for 3 seconds and close door.
The dishwasher will
Indicator Lights
7
SANITIZED Displayed at end of the cycle when WASH TEMP - SANITIZE has been selected and dishwasher
has met requirements for sanitization. See WASH TEMP - SANITIZE, for complete description.
Opening the door will turn off the light.
CLEAN Displayed when a wash cycle is complete. The light stays on as a reminder that the dishes are
clean. Opening the door will turn the light off.
Display
8
Time During operation, the display shows the total number of minutes remaining in the cycle. During a
Remaining delay start, the display will show hours of time remaining until the cycle starts.
Check
The entering water should be at least 120°F
(49°C) and not more than 150°F (66°C) for
the Water
effective cleaning and to prevent dish damage.
Temperature
Check the water temperature with a candy or
meat thermometer.
Sabbath/
To turn this option ON/OFF, press and hold the START and WASH TEMP buttons for 5 seconds,
close the door and wait 3 minutes for the dishwasher to go into sleep mode. In the OFF mode, the
Door Wake
control display, control sounds, and interior lights (on some models) will not respond to the door
Up Mode
opening/closing. This mode can be used when observing certain religious holidays such as the
Sabbath. To activate the control and interior lights (on some models), press any button.
Use a Rinse
Rinse agents, such as Finish® Jet-Dry® Rinse Aid are designed for great drying action and to
protect against spots and film build-up on your dishes, glasses, flatware, cookware, and plastic.
Agent
Filling the The rinse agent dispenser holds 3.9 oz. (115 ml) of rinse agent. Under normal conditions, this will
last approximately one month.
Rinse Agent
Dispenser
1
Make sure the dishwasher door is fully open.
2
Open the dispenser door. (Rinse agent compartment is on the
right side of dispenser.)
3
Slowly add rinse agent until the cup is full. You may need to
pause several times to allow rinse aid to settle.
4
Clean up any spilled rinse agent with a damp cloth to prevent
foam from forming inside the dishwasher.
6
5 Close the dispenser door.
drain, emit a beep sound, and the
Getting Started
Dishwasher
wash cycle light will turn off.
Turn on the hot water faucet nearest the
dishwasher, place the thermometer in a glass
and let the water run continuously into the glass
until the temperature stops rising.

Dispensers

Dishwasher