CESVA RS-60 Manual Del Usuario página 23

RS-60
User's manual
The remote display consists of illuminated indicators. It may therefore be consulted in the
dark. When the RS-60 is disconnected from the mains, the display goes out and ceases to
show information.
Sound level CORRECT
Alarm limit EXCEEDED
3.1.2 The DL100 giant remote display
The DL100 remote display may be connected to the RS-60 front panel. This display allows
you to observe the sound level pressure measured by the RS-60.
3.1.3 The REL-2 relay box
The REL-2 relay box has two relays, one corresponding to the pre-alarm situation and the
other to the alarm situation. When the sound pressure level measured by the sensor
(equivalent continuous level corresponding to the evaluation time) exceeds either the pre-
alarm or alarm limit, the corresponding relay switches during a switching time of between 1
and 180 seconds, and may activate or deactivate any kind of electrical signal (220 V / 1 A).
Different switching times may be programmed for pre-alarm and alarm situations. The alarm
relay always has priority over the pre-alarm relay.
Pre-alarm limit EXCEEDED
SENSOR ERROR
21