Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
ASSEMBLY STEP 3
HARdWARE fOR STEP 3 :
BOLT (A)
SPRING WASHER (B)
20 mm
8.2 mm
Qty: 6
Qty: 6
CONSOLE
CONSOLE MAST CAP
ARC WASHERS (C)
SPRING WASHERS (B)
BOLTS (A)
CONSOLE MAST
12
71AT_OM_Rev1_6.indd 12-13
Open hardware for step 3.
A
Connect the console cables, carefully
B
tucking wires in masts to avoid damage. It may
ARC WASHER (C)
8.2 mm
be helpful to have a second person for this step.
Qty: 6
gently place the console on top of the
C
console masts. Attach the left side first
using 3 bolts (g), 3 spring washers (b)
and 3 arc washers (c).
CONSOLE CABLES
NOTE: Be careful not to pinch any wires
while assembling the masts.
Attach the right side of the console
D
using 3 bolts (g), 3 spring washers (b)
and 3 arc washers (c).
ASSEMBLE
THIS SIDE
FIRST
Completely tighten all bolts from step 1.
E
ASSEMBLY STEP 4
HARdWARE fOR STEP 4 :
BOLT (F)
SPRING WASHER (G)
ARC WASHER (H)
12 mm
6.2 mm
6.2 mm
Qty: 4
Qty: 4
Qty: 4
HANDLEBARS
CONSOLE CABLES
CENTER BAR
ARC WASHERS (H)
SPRING WASHERS (G)
BOLTS (F)
A
Open hardware for step 4.
B
Connect the console cables, discard the
twist tie and slide the console cables into the
center bar.
C
Attach handlebars to center bar using 4
bolts (e), 4 spring washers (f) and 4 arc
washers (g).
NOTE: Do not tighten bolts until step 5 is complete.
Do not pinch wires while assembling the handlebars.
8/31/11 1:40 PM
13
Publicidad
Tabla de contenido
