Clarke Ultra Speed Pro 1500 Instrucciones De Uso página 3

OPERATION OF SPEED FLOOR MACHINES
READ OPERATORS MANUAL THOROUGHLY PRIOR TO OPERATING
OR SERVICING THIS MACHINE.
GENERAL USE
1. Remove any obstructions or other obstacles in the area which is to
be cleaned.
2. Place the handle in the upright position and tilt machine back until
handle rests on the fl oor
* Be sure the machine is not plugged into an outlet
3. Attach the pad to the machine by fi rst unscrewing the male end of
the "big mouth" from the fl exible pad driver. Place the approved pad
on the pad driver, place the male end of the "big mouth" into the
center hole of the pad, and tighten the "big mouth" fi rmly to the pad
driver.
4. Place machine back into its upright position.
5. Plug power cord into a grounded outlet. * Never use an extension
cord in conjunction with the standard power cord.
6. The handle height may be adjusted by lifting up the compression
handle which is located on the right side of the handle tube about
1 foot above fl oor level. Release the compression handle and
adjust handle to safe operating height, then push back down on the
compression handle to lock the handle in operating position.
7. To start the machine, press the red safety button on the top of the
upper switch housing, and then squeeze either of the operating
triggers. (the safety button must be depressed prior to squeezing the
operating triggers.)
8. When the machine is in operation, both hands should be placed on
the switch housing (upper handle).
9. To stop the machine at any time, simply release the operating
trigger(s) and the machine will stop automatically.
MAINTENANCE
To keep this machine performing well for many years, please follow the
following maintenance procedures:
Always confi rm the machine is unplugged from the power source
prior to performing any maintenance or repairs!
12/13
INSTRUCTIONS FOR USE
1. Unplug machine as soon as you are done using it.
2. Clean the outside of the machine with a mild cleaner.
3. Check power cord for any damage. If damage is detected, replace power
cord immediately.
4. Lubricate wheels with a water resistant lubricant once a month.
5. Check machine for loose or missing nuts and bolts, and replace as
necessary.
6. If the machine is used in a dusty environment, you may remove the motor
cover and blow the motor clean with compressed air. This will ensure
proper ventilation, and allow the motor to run cooler.
STORAGE
1. Unplug machine from power source and wrap cord on handle.
2. Tilt machine so the pad is not touching the fl oor.
3. Store machine in upright position and in a dry area.
HANDLE RELEASE ASSEMBLY INSTRUCTIONS
STEP 1
1) Remove nut and spacer from handle bracket assembly.
2) Push the two handle brackets backward so they lean against the rear
wheel.
STEP 2
1) Remove Handle Clamp Blocks (A) with 5mm hex head.
2) Place handle assembly into handle clamp blocks.
3) Re-attach the blocks to the base with 5mm hex head.
STEP 3
1) Make sure actual Cord Wrap (B) faces to the left of the machine when you
are standing behind it.
2) Assemble hardware in the following order; spacer, left handle bracket,
nylock nut. (do not over tighten nylock nut. Only tighten it enough to hold
handle in place when compression lever is in down position).
STEP 4
1) Connect Power Cords (C) together
B
C
A
56091114 - Ultra Speed Pro 1500
ENGLISH - A
A
A - 3