Delete Recordings - Southwire 15190T MaintenancePRO Instrucciones De Uso

Access Saved Recordings cont.
2. Use the F2 and F3 soft keys (Fig. 13) to the select Recorded File as shown below:
1st Saved File
...........................Last Saved File
F2 soft key:
Last Saved File
F3 soft key:
3. Press the F1 soft key to OPEN Recording (Fig. 13).
Fig. 14
The date and time the Recorded File was started is displayed above the graph. The reading
at the top of the display corresponds to the measurement point indicated by the vertical
cursor line on graph.
4. Momentarily press the F2 or F3
point or press and hold the soft key until reaching the desired point along the graph.
The time line shown on the bottom of the graph indicates the time each measurement
was recorded relative to the start of the recording (Fig. 14).
5. For greater resolution, momentarily press the F1 ZOOM soft key (Fig. 14) to expand the
graph as shown below (the graph will expand up to 64 times depending on the number
of measurement points):
1x 2x 4x
6. Press the F4 CLOSE soft key to exit Saved File (Fig. 14).
2nd Saved File 3rd Saved File
...............3rd Saved File 2nd Saved File
1st Saved File
soft key to move the cursor to the next measurement
8x 16x 32x 64x
19
Access Saved Recordings cont.
,
7. Use the soft keys to DELETE recording or CANCEL and return to Saved Recordings
without deleting (Fig. 15).

Delete Recordings

1. From Recordings Menu, select and ENTER Delete Recordings (Fig. 4).
2. Press the F1 soft key to DELETE ALL RECORDINGS (Fig. 16).
3. Press the F4 soft key to CANCEL and return to Recordings Menu without deleting (Fig. 16).
Fig. 15
Fig. 16
20