ECOVACS ROBOTICS DEEBOT 8 Manual De Instrucciones página 23

NO. Malfunction
DEEBOT 8
will not clean
4
automatically at
scheduled time.
Remote Control
failure (effective
5 control range of
Remote Control
is 5m (16')).
Possible Causes
Time Scheduling function is
cancelled.
The Bottom Power Switch
on the bottom of the robot is
OFF.
The robot's battery is low.
DEEBOT 8's components
are tangled with debris.
The batteries in the Remote
Control need to be replaced.
The Bottom Power Switch is
turned OFF, or DEEBOT 8's
battery is low.
The infrared signal cannot be
transmitted because the Infrared
Emitter on the Remote Control
or DEEBOT 8's Infrared
Receiver on DEEBOT 8 is
dirty.
There is other equipment
interfering with the infrared
signal to DEEBOT 8.
5. Troubleshooting
Solutions
Set Time Scheduling function as described
in section 3.4.
Turn the Bottom Power Switch to the ON
position.
Keep DEEBOT 8 powered ON and on the
Charging Dock to make sure it has a full
battery to work at any time.
Turn DEEBOT 8's Bottom Power Switch
OFF, clean the Dust Bin, and invert the
robot. Clean the Side Brushes and the
Main Brush as described in section 4
Maintenance.
Replace with new batteries making sure
they are installed correctly.
Make sure DEEBOT 8's Bottom Power
Switch is ON and fully charged.
Use a dry cloth or the Multi-Function
Cleaning Tool to wipe the Infrared Emitter
on Remote Control and the Infrared
Receiver on DEEBOT 8.
Avoid using the Remote Control near
other equipment using infrared signals.
21
EN