Operation - Makita PM7650H Manual De Instrucciones

Ocultar thumbs Ver también para PM7650H:
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

OPERATION

1. Starting
WARNING:
• Never attempt engine start in a place where the unit was refueled. When
starting the engine, keep a distance of at least 3 m (10 feet).
– Otherwise, it will may cause ignition or fire.
• Exhaust gas from the engine is toxic. Do not operate the engine in a poorly-
ventilated place, such as in a tunnel, building, etc.
– Operating the engine in the poorly-ventilated place may cause poisoning by
exhaust gas.
• In case of detection of any abnormality in sound, odor, vibration after start,
stop the engine immediately and carry out inspection.
– If the engine is operated without attending such abnormality, an accident
may occur.
• Make sure that the engine stops when the stop switch is set to "O" position.
1) When the engine is cold, or when the fuel it refueled
(1) Set this machine on a flat space.
(2) Set the stop switch to " I " position.
(3) Verify that the cruise control lever is in the low-speed position.
(4) Continue to push the primer pump until fuel enters into the primer pump.
– In general, fuel enters into the carburetor by 7 to 10 pushes.
– If the primer pump is pushed excessively, an excess of gasoline returns to
the fuel tank.
(4)
Primer pump
Choke
lever
(2)
(3)
Close
14
Stop
switch
High speed
Low speed
Cruise
control lever

Publicidad

Tabla de contenido
loading

Este manual también es adecuado para:

Pm7650hg

Tabla de contenido