Operation; Maintenance - Makita UB401MP Manual De Instrucciones

3.
Attach the flat nozzle or extension nozzle
to the adapter pipe, and then turn it to lock it into
place.
1
2
► 1. Flat nozzle 2. Extension nozzle 3. Adapter
pipe
NOTICE:
The grooves on the deep side
of the flat nozzle or extension nozzle are
not available. Be sure to use the grooves
shown in the figure to attach the flat nozzle
or extension nozzle.

OPERATION

WARNING:
Follow the warnings and
precautions in the chapter "SAFETY
WARNINGS" and the instruction manual of
the power unit.
WARNING:
Adjust the hanger position
and shoulder harness to your comfortable
position before operating.
CAUTION:
Do not place the machine on
the ground while it is switched on. Sand or
dust may enter from suction inlet and cause a
malfunction or personal injury.
Hold the machine firmly with both hands and per-
form the blowing operation by moving it around
slowly. When blowing around building, big stone
or vehicle, direct the nozzle away from them.
When performing an operation in a corner, start
from the corner and then move to wide area.
Adjust the air speed with the switch trigger or
throttle lever of the power unit according to the
environment or conditions of your usage.
3
Noise rating
The following is the maximum noise rating when
the blower attachment is used in conjunction with
EX2650LH Multi Function Power Head, accord-
ing to ANSI B 175.2.
Noise rating: 70 dB(A)

MAINTENANCE

WARNING:
taining the equipment, switch off the motor
and remove the battery cartridge, or stop
the engine and remove the spark plug cap.
Otherwise, the fans may move and result in
serious injury.
WARNING:
taining the equipment, always put it down.
Assembling or adjusting the equipment in an
upright position may result in serious injury.
WARNING:
precautions in the chapter "SAFETY
WARNINGS" and the instruction manual of
the power unit.
NOTICE:
thinner, alcohol or the like. Discoloration,
deformation or cracks may result.
To maintain product SAFETY and RELIABILITY,
repairs, any other maintenance or adjustment
should be performed by Makita Authorized or
Factory Service Centers, always using Makita
replacement parts.
10 ENGLISH
Before inspecting or main-
When inspecting or main-
Follow the warnings and
Never use gasoline, benzine,