Getting Started - Hama RC 600 Instrucciones De Uso

4. Getting Started

Open the battery compartment (6) and insert two AA batteries with the correct polarity. Close the battery
compartment.
5. Operation
5.1 Automatic date/time setting using the DCF signal
After the batteries are inserted, the display is switched on and an acoustic signal sounds for 2 seconds. The
clock automatically searches for the radio signal. This process can take 3 to 5 minutes. When the wireless
signal is received, the date and time are automatically set and the radio icon
automatically receives the time code every hour.
If the clock is unable to receive a time signal wirelessly, the time/temperature are displayed and the radio icon
is not visible. In this case, you can set the time manually.
5.2. Manually setting the time
Press MODE (5) for 3 seconds in the time/temperature display to set the system date and time. The
disappears. However, if you are within the range of the radio signal, the clock will automatically try to receive
the radio signal.
• Press MODE (5):
the hour digits are blink and can be set by pressing
• Press MODE again (5):
the minute digits are blink and can be set by pressing
• Press MODE again (5):
the year digits are blink and can be set by pressing
• Press MODE again (5):
the month digits are blink and can be set by pressing
• Press MODE again (5):
the date digits is blink and can be set by pressing
• Press MODE one last time (5): the normal time display appears.
Note
• If no key is pressed within 30 seconds, it will exit the Manual Time Setting Mode and go back to
Time/Temperature Display without the data update
• During any setting mode, press and hold
5.3 12/24-hour display format
Press the button (3) to switch between the 12 and 24-hour formats. In the 12-hour format, AM or PM
appears before the time.
4
or (3) key.
or (3) key.
or (3) key.
or (3) key.
or (3) key.
or key for 2 seconds for fast setting
is displayed. The clock
icon