Miele UO 5005-30 Instrucciones De Montaje página 26

Produktgruppe 591
26 von 28
am
Parts required
Quantity Mat. no.
1 01496700
1 01514720
Note
Service and repair work should only be carried out by a suitably qualified electrician (with specialist training, knowledge and experience,
and recent related work experience) in accordance with all appropriate local and national safety regulations.
Servicing, modification, testing and maintenance of electrical appliances should only be carried out in accordance with all appropriate
legal requirements, accident prevention regulations and valid standards.
All regulations of the appropriate utility supply companies and standards relating to safety (not limited to electrical safety) are to be
complied with.
Danger!
Risk of injury during installation:
Risk of electric shock. Even with the machine switched off, voltage may be applied to some components.
Install the stand only on machines that are not operational. For disassembly instructions, refer to the operating instructions for the
appliance.
Wear non-slip palm gloves and safety shoes to protect from injury.
Make sure that no body parts, especially hands and feet, get stuck under or between the machines.
Keep children and animals out of the work area during installation.
Danger of appliance tipping over. Danger of injury due to faulty installation.
Always bolt the stand and the appliance together.
Bolt the stand to the floor with the floor installation kit, mat. no. 01497252 (included in this kit).
Do not use the stand for a stacked washer/dryer combination.
Note
The stand is only for Miele appliances:
PW 5062, PW 5064, PW 5065, PW 6055, PW 6065
WS 5425, WS 5426, WS 5427, WS 5428
PT 5135C, PT 5136, PT 7135C, PT 7136
T 5205C, T 5206
Note
Required tools:
Level for leveling the stand(s)
10 mm open-end wrench, for M6 nuts
Torx 20 screwdriver
Disconnect the machine from the power supply and ensure that it cannot be switched on again in error.
Stand UG 5005-30: Disassemble the machine casing:
Remove the front panel (Fig. 8).
Remove the side panels (Fig. 8).
12.09.2012 Diese Unterlagen dürfen ohne unsere Genehmigung weder vervielfältigt noch Dritten zugänglich gemacht werden. Eigentumsrechte vorbehalten.
Umbau- und Montageanweisung
Designation
Stand UO 5005-30
Stand UG 5005-30
M.-Nr. 04891571