Making An Audio Recording; To Set For Automatic Standby Status (Auto Power Down); Restoring All The Settings To The Factory Default Settings - Pioneer A-70DA-K Manual De Instrucciones

04 Operation

Making an audio recording

You can make an audio recording from any audio source connected to the amplifier.
SACD/CD player
1 Select the source you want to record.
12
En
iPod dock, etc
Turntable
iPod
Music>
Extras>
Settings>
Network audio player
Shuffle Songs
Backlight
MENU

/I STANDBY/ON
SOURCE SOURCE  
STANDBY DIRECT Hi-Bit 32 Up Sampling
 

iPod/iPhone 5V 1A
Playback
Recording
1
Audio recording component
(CD recorder, tape deck, etc.)
2 Start recording, then start playback of
the source component.
Caution
• Confirm that the short pin plugs are not inserted in
the LINE 2 OUT terminals, since malfunction will
result if they are inserted.
• Audio connected to the following terminals cannot
be output from the LINE 2 OUT terminals.
-
LINE 2 IN
-
BALANCED IN
-
POWER AMP DIRECT IN

To set for automatic standby status (Auto Power Down)

This function automatically switches the unit to standby mode if no signal or switch operation is detected for 30
minutes.
1 If the unit's power is ON, press the APD button on the remote control.

When this condition is set to ON, the STANDBY/APD indicator on the unit's front panel will light green. Press the
buttons again to disable the setting.
• This setting can also be made by pressing the front panel LOUDNESS button and POWER AMP DIRECT button
simultaneously and holding them depressed for 3 seconds.
• The factory default setting is ON.
• Rotating the TREBLE, BASS, BALANCE, or VOLUME controls will not be counted as a control operation for
purposes of resetting the Automatic Power-Down 30-minute timer.
Note
• Depending on the connected devices, the unit may not be automatically powered down for reasons such as there
being a lot of noise.

Restoring all the settings to the factory default settings

1 When power is in standby mode, hold the front-panel's SPEAKERS A button and
POWER AMP DIRECT button depressed simultaneously for five seconds.
2 Turn power ON to the unit.