Sony HT-CT390 Manual De Instrucciones página 27

Others
The Control for HDMI function does not
work properly.
 Check the connection with the
system (refer to the supplied
Startup Guide).
 Enable the Control for HDMI
function on the TV. For details, refer
to the operating instructions of your
TV.
 Wait a while, and then try again. If
you unplug the system, it will take a
while before operations can be
made. Wait for 15 seconds or
longer, and then try again.
 Make sure the devices connected to
the system support the Control for
HDMI function.
 Enable the Control for HDMI
function on the devices connected
to the system. For details, refer to
the operating instructions of your
device.
 The type and number of devices
that can be controlled by the
Control for HDMI function is
restricted by the HDMI CEC standard
as follows:
• Recording devices (Blu-ray Disc
recorder, DVD recorder, etc.): up
to 3 devices
• Playback devices (Blu-ray Disc
Player, DVD player, etc.): up to 3
devices
• Tuner-related devices: up to 4
devices
• Audio system (receiver/
headphone): up to 1 device (used
by this system)
If "PRTCT" appears in the top panel
display of the Bar Speaker.
 Press  to turn off the system. After
the display turns off, disconnect the
AC power cord (mains lead) then
check that nothing is blocking the
ventilation holes of the Bar Speaker.
The top panel display of the Bar
Speaker is not lit.
 Press DIMMER to set the brightness
to "BRIGHT" or "DARK", if set to
"OFF" (page 9).
Sensors of the TV do not work properly.
 The Bar Speaker may block some
sensors (such as the brightness
sensor) and the remote control
receiver of your TV, or the "emitter
for 3D glasses (infrared
transmission)" of a 3D TV that
supports the infrared 3D glass
system or the wireless
communication. Move the Bar
Speaker away from the TV within a
range that allow those parts to
operate properly. For the locations
of the sensors and remote control
receiver, refer to the operating
instructions supplied with the TV.
Reset
If the system still does not operate
properly, reset the system as follows.
Be sure to use the touch keys on the Bar
Speaker to perform this operation.
1
While holding INPUT, touch VOL –
and  simultaneously for
5 seconds.
"RESET" appears in the top panel
display, and the settings of the
menu and sound fields, etc. return
to their initial status.
2
Disconnect the AC power cord
(mains lead).
3
Connect the AC power cord (mains
lead), then press  to turn on the
system.
4
Link the system to the subwoofer
(page 21).
27
US