Replacement Parts; Before Returning For Repairs - Schumacher Electric DSR Industrial series Manual Del Usuario

PROBLEM
Charger will not turn on
when properly connected.
Battery clips do not spark
when touched together.
17.

REPLACEMENT PARTS

Output Cables (INC-406A)
Output Cables (INC-406AC)
18.

BEFORE RETURNING FOR REPAIRS

18.1 When a charging problem arises, make certain that the battery is capable
of accepting a normal charge. Use a good battery to double check all
connections, the AC outlet for a full 120-volts, the charger clips for correct
polarity and the quality of the connections from the cables to the clips and from
the clips to the battery system. The clips must be clean.
18.2
When a battery is very cold, partially charged or sulfated, it will not draw
the full rated amperes from the charger. It is both dangerous and damaging
to a battery to force higher amperage into it than it can effectively use in
recharging.
18.3 When an UNKNOWN OPERATING PROBLEM arises, please read the
complete manual and call the customer service number for information that will
usually eliminate the need for return.
If the above solutions do not eliminate the problem or for information about troubleshooting
or replacement parts, call toll-free from anywhere in the U.S.A.
POSSIBLE CAUSE
AC outlet is dead.
Poor electrical connection.
The charger is equipped
with an auto-start feature.
It will not supply current
to the battery clips until
a battery is properly
connected. Unlike
traditional chargers, the
clips will not spark if
touched together.
1-800-621-5485
7:00 am to 5:00 pm Central Time Monday thru Friday
REASON/SOLUTION
Check for open fuse or
circuit breaker supplying AC
outlet.
Check power cord and
extension cord for loose
fitting plug.
No problem, this is a normal
condition.
10
• •
38-99-000679
22-99-001838