Urrea CC910 Manual De Usuario Y Garantía página 20

hazardous condition leading to possible seri-
ous personal injury.
WARNING: Do not connect to power sup-
ply until assembly is complete. Failure
comply could result in accidental starting and
possible serious personal injury.
INSTALLING THE WATER TRAY FRAME TO
THE LEG STAND
A. Leg stand
B. Flat Washer
· Lock the table stop by-pass by pulling up on
the stop and turning it until the slot in the
center of the lock is horizontal (left to right).
· Pull the sliding table to the front of the
frame. From under the right side of the table,
align the hole in the rail with the pin in the
sliding table lock lever. Push the pin into the
rail locking the table.
· Align the hole on the water tray frame with
the hole on the stand.
· Insert short carriage bolts into holes and
tighten securely using lock nuts.
INSTALLING MOTOR HEAD ASSEMBLY TO
WATER TRAY FRAME
A. Motor head assembly
B. Cap bolt (short)
C. Cap bolt (long)
D. Water tray frame
20
to
C. Short carriage bolt
D. Water tray frame
E. Sleeve
F. Washer
G. Lock nut
· Align the holes in the motor head assembly
with the holes on the side of the water tray
frame.
· Insert short cap bolts. Finger tighten using
nuts.
· Slide long cap bolts into sleeve. Insert into
holes. Finger tighten.
· Tighten all cap bolts using an 8 mm hex key.
INSTALLING THE PARTICLE TRAP
A. Particle trap
B. Grooves
· Unlock the sliding table and pull the table to
the front of the water frame.
· Slide the particle trap into the groves on the
underside of the sliding table.
INSTALLING THE WATER TRAY
From the right side of the saw, place the water
tray (drain plug end to the left) on the lip at
the bottom of the water tray frame. Slide the
water tray in under the sliding table.
A. Water tray frame
INSTALLING THE MITER GUIDE
The miter guide can be used from both the left
and right side of the cutting wheel.
· Place the slot on the underside of the miter
guide on the sliding table fence.
C. Sliding table
B. Water tray