Urrea CC910 Manual De Usuario Y Garantía página 25

WARNING: Before performing any adjust-
ment, make sure the tool is unplugged from
the power supply and the switch is in the OFF
position. Failure to heed this warning could
result in serious personal injury.
The saw has been adjusted at the factory for
making very accurate cuts. However, some of
the components might have been jarred out
of alignment during shipping. Also, over a
period of time, readjustment will probably
become necessary due to wear.
Do not start any adjustments until you have
checked with a square and made test cuts to
be sure adjustments are needed.
TO SQUARE THE CUTTING WHEEL TO THE
TABLE
Do not loosen any screws for this adjustment
until you have checked with a square and
made test cuts to be sure adjust- ments are
necessary. Once the screws are loosened, these
items must be reset.
· Unplug the saw.
· Using a hex key, loosen hex bolts on the left rail.
· Place a framing square against the fence and
the flat part of the wheel.
· Using the set screw to adjust, move the table
until the fence is square with the cutting
wheel.
· Tighten the hex bolts securely.
TO ADJUST THE TABLE ROLLERS
If the table doesn't slide smoothly, seems too
loose on the rails, or moves side to side, ad-
justments may be required. To adjust if the
table is loose:
· Insert hex key through the hole in the left side
of the table.
A. Framing square
E N G L I S H •
Loosen the cam bolt nut. These bolts can be
adjusted up and down by turning the bolt.
· Once the rollers are touching the rail, tighten
the cam bolt nut securely. Repeat for each
roller as required.
NOTE: Check that rollers are sliding properly
after each adjustment.
DEPTH STOP ADJUSTMENTS
The depth stop limits the wheel's downward
travel. It allows the wheel to go below the ta-
ble enough to maintain full cutting capacities.
The depth stop is factory set to provide maxi-
mum cutting capacity for the wheel provided
with the saw. Make adjustments if needed.
· Unplug the saw.
· To adjust the depth stop, loosen the wing nut
located on the depth stop.
· Turn the depth stop adjustment screw. Set the
wheel to the correct cutting depth (wheel just
below the table surface). Lower the cutting
wheel to the table to check wheel clearance.
· Readjust if necessary.
· Tighten the wing nut.
POSITIVE STOP ADJUSTMENTS
NOTE: These adjustments were made at the
factory and normally do not require readjust-
ment.
· Unplug the saw.
If the cutting wheel is not perfectly vertical (0°):
· Loosen the bevel lock knob.
· Place a combination square beside the wheel.
· Using a wrench, turn the 0° hex bolt until the
wheel is square to the table and the hex bolt is
resting on the saw housing.
A. Lock knob
B. 0° Hex bolt
U se r's m a nua l
C. 45° Hex bolt
25