Baby Jogger city select lux Instrucciones Para El Ensamblaje página 10

EN
FRAME
1 Unpack the stroller frame from the box
and set the wheels aside. Unlock the
stroller by pulling the
Storage Lock Lever.
2 Lift the Handlebar away from the lower
frame. The stroller will click into place.
3 Place the stroller in the upright position.
WARNING: Ensure that all the locking
devices are engaged before use.
FRONT WHEEL
4 Installation
• Lay stroller on its back so the
Handlebar is resting on the floor.
• Attach the Front Wheel by sliding it
into the front wheel mount until it
clicks. Gently pull on the Front Wheel
to make sure it is properly attached.
5 Removal
• While pressing the front wheel release
button, gently slide the Front Wheel
out of the front wheel mount.
SWIVEL FEATURE
6 Press the Swivel Lock button down
and slide the Swivel Lock to the left to
lock the front wheel assembly in a fixed
position for long distance strolling.
7 Press the Swivel Lock button down
and slide the Swivel Lock to the right
to allow the front wheel assembly to
swivel.
WARNING: When loading and
unloading child, lock the front wheel in
a fixed position. Although the
front wheel of your stroller locks, it is
not intended for jogging or exercise
purposes.
REAR WHEELS
8 Installation
• Align the Rear Wheel axle with the
wheel mount on the stroller frame
and insert it into the wheel mount
until it clicks into place.
• Gently pull on the Rear Wheel to
make sure it is properly attached.
9 Removal
• While pressing the Wheel Release
Button, gently slide the Rear Wheel
out of the wheel mount.
BRAKE
10 To engage quick brake squeeze on the
brake lever.
11 To Lock the Brakes: gently push the
Brake Lever forward until it clicks into
place.
12 To Release the Brakes: Pull the Parking
brake lock towards you.
WARNING: Lock the brakes before
loading and unloading your child and
whenever the stroller is not moving.
SEAT - UNFOLD THE SEAT
13 Holding the footwell and the top of the
seat, open the seat.
14 The seat will lock into its open position.
CANOPY
15 Attach the canopy to the frame: Attach
the Canopy' s brackets to the sides of
the seat frame.
16 Attach the 2 fastening strips on the
canopy to the top of the seat.
ADJUSTING SAFETY HARNESS
17 From the back of the seat, undo the
fastening strip and open the pocket to
locate the plastic square stopper. Turn
stopper and pass through the openings
in the PE board and seat fabric.
18 Reinsert stopper at seat opening closest
to child' s shoulders. Pass back through
seat fabric and PE board. Tug on strap
to ensure stopper is locked. Repeat on
both sides.
WARNING: Avoid serious injury from
falling or sliding out. Always properly
adjust and fasten safety harness.
WARNING: Always use the crotch strap
in combination with the shoulder straps
and waist belt.
19 Slide the Harness Pads up to access
plastic guide on strap.
20 Hold the plastic guide and pull strap to
tighten or loosen.
10