Kobalt KST 2040-06 Manual De Instrucciones página 13

ASSEMBLY INSTRUCTIONS
5. Cutting line
A spool of cutting line is pre-installed on the trimmer.
When the cutting line needs replacing, insert a new spool
(not included) or rewind new line onto existing spool.
CAUTION: To avoid injury, always remove the
battery before installing the guard, changing a cutting line, or
making any adjustments.
5a. To remove the spool :
a. Remove the battery from the trimmer.
b. Turn the string trimmer over to access the spool.
c. Remove the spool cover (L) by pressing on the two
tabs parallel to each other on the sides of the spool
cover (L).
d. Remove the spool (M) from the spool
housing (O) and remove any excess line.
5b. To replace the spool:
a. Replace the spool (M) with a new pre-wound
spool (not included) or a re-wound spool.
b. Insert the ends of the line through the line
openings （N） in the spool housing.
c. Align the tabs on the spool cover (L) with the slots
in the spool housing (O) on the trimmer head.
d. Push down on the spool cover (L), locking it to the
spool housing (O).
5a
5b
5c
5d
13
Tab