Thermal Alarm; Combustion Chamber Pressure Alarm - Bio Bronpi Berta Instrucciones De Instalación, Uso Y Mantenimiento

9.7

THERMAL ALARM

If during the working phase the thermal security alarm shows up (see drawing D34), the turn-off stage
will be immediately activated. This alarm means an overheating of the internal part of the storage
tank; this device locks the operation of the machine. The restart needs to be done manually by an
authorised technician.
The restoration of the 90ºC safety device is not included in the warranty unless the technical assistance
centre demonstrates a faulty component.
9.8

COMBUSTION CHAMBER PRESSURE ALARM

This alarm is triggered when there is a pressure change in the combustion chamber (door open, dirty
ash reservoirs, down draughts, blocked flue, etc). The electronic pressure switch locks the operation of
the stove and shows the alarm.. After that the turn-off stage will be immediately activated (see drawing
D35).
During the alarm status, the stove will be in the turn-off stage. You must reset the alarm pressing the
display button for 3 seconds.
INSTALLATION, OPERATING AND SERVICING INSTRUCTIONS 23
Blue
D34
Red
Blue
D35
Red
MOD. BERTA