Beta 1885/KF Manual Del Usuario página 23

OPERATION MANUAL AND INSTRUCTIONS ISTRUZIONI PER L'USO
- The cursor will automatically select "oil lt.". Press the
system to be changed. After the amount of oil has been set, press the
- If the data about the solvent, cleaning and oil have been set, the station will start performing the work cycle from step 1,
"Feeding solvent", and the display will show the amount as it is injected into the automatic transmission circuit.
- If the startup screen shows that the amount of solvent has been set to "0", the station will automatically skip STEP 1 and
immediately move on to STEP 2.
STEP 2
- After STEP 1 has been completed, the station will proceed to STEP 2, "Cleaning", requiring the user to have started the car
with the gearshift in the parking ("P") or neutral ("N") position. The display will show the following:
- Start the car keeping the gearshift in "P" or "N" position, and quickly press the
circuit, filtering impurities, and then show the time remaining to the end of the operation. During cleaning, as the car has been
placed on a lift with raised wheels, all the gears – including the reverse gear – should be shifted a few times.
Cleaning must be performed with warm transmission oil.
- If in the startup page both the amount of solvent and the duration of the cleaning cycle have been set to "0", the station will
automatically skip STEP 1 and STEP 2, and immediately move on to STEP 3.
STEP 3
- When the set time has elapsed, the station will emit a few beeps, and STEP 3, "Changing converter oil", will automatically
start. The display will show the amount of oil to be changed.
- Then press the key. The station will require the user to start the car with the gearshift in the parking ("P") or neutral ("N")
position, the message being shown on the display.
key to set the total amount of oil in the automatic transmission
key.
key. The station will start cleaning the
EN I
23