General Safety Notes And Driving Restrictions - Breezy RubiX2 Manual De Usuario

General safety notes and driving restrictions

The engineering and construction of this wheelchair has been
designed to provide maximum safety. International safety standards
currently in force have either been fulfilled or exceeded in parts.
Nevertheless, users may put themselves at risk by improperly using
their wheelchairs. For your own safety, the following rules must be
strictly observed.
Unprofessional or erroneous changes or adjustments increase the
risk of accident. As a wheelchair user, you are also part of the daily
traffic on streets and pavements, just like anyone else. We would
like to remind you that you are therefore also subject to any and all
traffic laws.
Be careful during your first ride in this wheelchair. Get to know your
wheelchair.
Before each use, the following should be checked:
• Fixed axles or Quick-release axles on the rear wheels.
• Velcro on seats and backrests
• Tyres, tyre pressure and wheel locks.
Before changing any of the adjustments of this wheelchair, it is
important to read the corresponding section of the user's manual.
It is possible that potholes or uneven ground could cause this
wheelchair to tip over, especially when riding uphill or downhill.
When riding forwards over a step or up an incline, the body should
be leaning forward.
DANGER!
NEVER exceed the maximum load of 125 kg, (XL=170 kg), for user
plus any items carried on the wheelchair. If you exceed the
maximum load, this can lead to damage to the chair, or you may fall
or tip over, lose control and may lead to serious injury of the user
and other people.
• When it is dark, please wear light clothing or clothing with
reflectors, so that you can be seen more easily. Make sure that
the reflectors on the side and back of the wheelchair are clearly
visible.
• We would also recommend that you fit an active light.
• To avoid falls and dangerous situations, you should first practice
using your new wheelchair on level ground with good visibility.
• When getting on or off the wheelchair, do not use the footboards.
• These should be flipped up beforehand and swung to the outside
as far as possible. Always position yourself as close as possible to
the place where you wish to transfer to.
• Only use your wheelchair with care. For example, avoid travelling
against an obstacle without braking (step, kerb edge) or dropping
down gaps.
10°
10°
78 RubiX
2
The wheel locks are not intended to stop your wheelchair in
•
motion. They are only there to ensure that your wheelchair
does not begin rolling unintentionally. When you stop on
uneven ground, you should always use the wheel locks to
prevent unintended movement. Always apply both wheel locks;
otherwise, your wheelchair could tip over.
Explore the effects of changing the centre of gravity on the
•
behaviour of the wheelchair in use, for example on inclines,
slopes, all gradients or when overcoming obstacles. Do this
with the secure aid of a helper.
With extreme settings (e.g. rear wheels in the most forward
•
position) and less than perfect posture, the wheelchair may tip
over even on a level surface.
Lean your upper body further forward when going up slopes
•
and steps.
Lean your upper body further back when going down slopes
•
and steps. Never try to climb and descend a slope diagonally.
Avoid using an escalator which may lead to serious injury in the
•
event of a fall.
Do not use the wheelchair on slopes more than 10°. The
•
Dynamic safe slope is dependant on the chair configuration, the
users abilities and the style of riding. As the users abilities and
style of riding cannot be predetermined then the max safe slope
cannot be determined. Therefore this must be determined by
the user with the assistance of an attendant to prevent tipping.
It is strongly recommended that inexperienced users have Anti-
tips fitted.
It is possible that potholes or uneven ground could cause this
•
wheelchair to tip over, especially when riding uphill or downhill.
Do not use your wheelchair on muddy or icy ground.
•
Do not use your wheelchair where pedestrians are not allowed.
•
To avoid hand injuries do not grab in between the spokes or
•
between the rear wheel and wheel lock when driving the
wheelchair.
In particular when using lightweight metal handrims, fingers will
•
easily become hot when braking from a high speed or on long
inclines.
Only attempt stairs with the help of an attendant. There is
•
equipment available to help you, e.g. climbing ramps or lifts,
please use them. If there is no such equipment available, then
the wheelchair must be tipped and pushed, never carried, over
the steps (2 helpers). We recommend that users over 100 kg in
weight are not transferred in this way. In general, any anti-tip
tubes fitted must be set beforehand, so that they cannot touch
the steps, as otherwise this could lead to a serious tumble.
Afterwards the anti-tip tubes must be set back to their correct
position.
Make sure that the attendant only holds the wheelchair using
•
securely mounted parts. Do not use removable parts (e.g. not
on the footrests or the side guards).
When using the lifting ramp make sure that the anti-tip tubes
•
fitted are positioned outside the danger area.
Secure your wheelchair on uneven ground or when transferring,
•
e.g. into a car, by using the brakes.
When using the lifting ramp make sure that the anti-tip tubes
•
fitted are positioned outside the danger area.
Secure your wheelchair on uneven ground or when transferring,
•
e.g. into a car, by using the brakes.
If and whenever possible, during a journey in a specially fitted
•
vehicle for disabled people, vehicle occupants should use the
seats in the vehicle and the appropriate restraint system. This is
the only way to ensure that occupants will have the maximum
protection if there is an accident.