Installation; Secure The Holder In The Module; Tools Required - Miele professional A 602 Instrucciones De Manejo

Tools required:

Secure the holder in the module

– Spanner, 9 mm (SW 9)
– TORX T20 screwdriver
There are holes in the cross rail of the module which the holders are
screwed into.
Place the holder along the cross rail in the module.

Secure the screws together with washers.

The two hoses for the rinse attachments on the casing of the Xi
stapler must be connected to the module water inlet tube.
Remove two blind stoppers on the front side of the water inlet tube.

Screw the hoses from the holder to the water inlet tube.

en - Installation
41