Makita DFL651F Manual De Instrucciones página 8

Adjusting the fastening torque
2
1
► 1. Screw 2. Ring 3. Clutch case
1
► 1. Scale 2. Hole for adjusting grip 3. Yellow line
When you wish to drive machine screws, wood screws,
hex bolts, etc. with the predetermined torque, adjust the
fastening torque as follows.
1. First remove the battery cartridge from the tool.
2. Remove the protector from the clutch case.
3. Loosen and remove the screw that secures ring.
4. Rotate the ring on the tool by hand so that a hole
can be seen below the ring.
5. Place the battery cartridge in place and pull the
switch trigger. Release it so that the adjusting ring
rotates and the hole becomes visible as illustrated.
And then remove the battery cartridge.
1
► 1. Adjusting grip
3
2
3
6. Use an optional adjusting grip to adjust the fasten-
ing torque. Insert the pin of the adjusting grip into
the hole on the tool. And then, turn the adjusting
grip clockwise to set a greater fastening torque,
and counterclockwise to set a smaller fastening
torque.
7. Align the edge of the adjusting ring with your
desired number on the fastening torque scale.
8. Insert the battery cartridge and be sure that a fas-
tening torque has been set up by using a fastening
torque tester.
9. Rotate the ring on the tool and then tighten the
screw to secure the ring.
10. Attach the protector back to the clutch case.
NOTE:
• Numbers on the fastening torque scale is a
guideline to set up your desired fastening
torque.
Adjusting no-load speed and
revolution angle etc.
2
► 1. USB cable 2. USB port
After installing application soft in your computer, using
USB cable allows no-load speed and revolution angle
adjustment etc. of the tool.
NOTE: For application soft, please contact Makita
sales representative.
ASSEMBLY
CAUTION:
• Always be sure that the tool is switched off and
the battery cartridge is removed before carrying
out any work on the tool.
Selecting correct socket
There are different types of sockets for some models
depending on applications. Choose and install a correct
socket for your application.
8 ENGLISH
1