Operation; Turning On Indicator; Turning Off Indicator; Zero Operation - OHAUS CW-11 Manual De Instrucciones

EN-28

4. OPERATION

Before using the Indicator, make sure it has been properly set up and calibrated. Refer to Sections 2 and 3 and
review settings. Four buttons are used: ON/ZERO/ OFF = power on or OFF, PRINT/ UNITS = short press =prints
data, long press= changes unit of measure, G/N/T/ MENU - short press = view gross net, or tare, long press =
enter setup menu, TARE - short press = enter tare.
Center
Gross
of Zero Brutto
Gross
Center
Brutto
of Zero
Gross
Brutto
Gross
Brutto
Center
of Zero
Net

4.1 Turning On Indicator

Press and hold ON/ZERO/ OFF button until the LCD
display appears, then release ON/ZERO/ OFF button.
The display momentarily displays segment check,
the software revision of the Indicator and then goes
into a weighing mode. If the Indicator has been
properly set upand connected, the display should
be as shown to the left. The decimal point position
may be different depending on the setup of the
Indicator.

4.2 Turning Off Indicator

To turn the Indicator off, press the ON/ZERO/ OFF
button until OFF is displayed.

4.3 Zero Operation

short short
Using a short short short duration press, press ON/ZERO/ OFF
button to zero the Indicator. The display acknowl-
edges by indicating the selected measuring unit
followed by a zeroed display.
NOTE: Stable cursor must be lit to accept zero
operation.
Place item to be weighed on the scale platform.
The display indicates a sample of 5kg, gross
weight.

4.4 Tare Operation

When weighing material or objects that must be held
in a container, taring stores the container weight in the
Indicator's memory. To store the container weight,
proceed as follows:
Place the container on the scale. Sample shown is
2kg.
Press TARE button. Scale is tared and shows Net
weight.
CW-11 Indicator