Bevel Cutting; Dust Extraction - Makita 4324 Manual De Instrucciones

Anti-splintering device (optional accessory)
1
For splinter-free cuts, the anti-splintering device can be
used. To install the anti-splintering device, move the base
all the way forward and insert it between the two protru-
sions of the base.
NOTE:
• The anti-splintering device cannot be used when
making bevel cuts.

Dust extraction

1
2
Clean cutting operations can be performed by connecting
this tool to a Makita vacuum cleaner. Insert the hose of
the vacuum cleaner into the hole at the rear of the tool.
Lower the dust cover before operation.
NOTE:
• Dust extraction cannot be performed when making
bevel cuts.
OPERATION
1
2
002732
1. Anti-splintering
device
2. Protrusions
2
002772
1. Dust cover
2. Hose
002743
1. Cutting line
2. Base
CAUTION:
• Always hold the base flush with the workpiece. Fail-
ure to do so may cause blade breakage, resulting in
a serious injury.
• Advance the tool very slowly when cutting curves or
scrolling. Forcing the tool may cause a slanted cut-
ting surface and blade breakage.
Turn the tool on without the blade making any contact
and wait until the blade attains full speed. Then rest the
base flat on the workpiece and gently move the tool for-
ward along the previously marked cutting line.

Bevel cutting

CAUTION:
• Always be sure that the tool is switched off and
unplugged before tilting the base.
• Raise the dust cover all the way before making
bevel cuts.
With the base tilted, you can make bevel cuts at any
angle between 0° and 45° (left or right).
Loosen the bolt on the back of the base with the hex
wrench. Move the base so that the bolt is positioned in
the center of the cross-shaped slot in the base.
6
002749
002748
1. Hex wrench
2. Bolt
1
3. Base
2
3