Faber UNIX Manual De Instrucciones página 39

USE

To get the cooker hood up keep the button T1 pushed for around 3 seconds; once the
threshold of around 200mm has been exceeded the motor will start working at first speed,
courtesy light will switch on automatically and all other functions become available.

Pushing the button T1 it is possible to stop and start again the cooker hood going up until it
get on the desired position or until cooker hood trolley will get to upper end guide.

To get the cooker hood down keep the bottom T3 pushed for around 3 seconds and to
stop the going down, push it again until the desired position

During the going down, till the threshold of around 200mm has not been exceeded, all
functions are available it is possible to invert the cooker hood running direction keeping
pushed button T1 to get it go up and T2 to get it go down

The emergency status will occur in two cases:
1-Opening the cooker hood perimetral panel. To reset the cooker hood, keep pushed
button T1 for 3 seconds.
2-When anti pinch safety system is working during the going down, the cooker hood
will immediately invert the running direction until trolley will get to upper end guide. In
that case, all functions are disabled for about 60 sec.
EN
Cooker Hood Commands
Pushing light button, Start led will be switched on. Pushing it again
they will be switched off
On/off Motor; First motor speed; Starting going up trolley; Stopping
going up trolley; Reinstatement of emergency status
Second speed;
Third speed; Starting going down trolley; Stopping going down
trolley
Pushing this button the motor keep working at the selected speed
for 15 minute, than all fuctions will be switched off and trolley will
get down
39