Electrical Connection; Connection Of The External Remote Control; Confi Gurations - S&P CADB/T-N PRO-REG Instrucciones De Uso

7.5.2. Electrical connection

In the recovery unit PRO-REG range, all components integrated into the device, are supplied into
the electrical panel (motors, pressure fi lters, motor pressure switches, temperature sensors,
batteries and by-pass damper).
The electrical connection is limited to the connection of control terminal (10 m. of supplied ca-
ble) and possible electrical accessories as such as CO
and fi nally the connection of the power supply line.
Make electrical connection in accordance with the described in the corresponding wiring dia-
gram, found in this manual.
7.5.2.1. External Touch Display (ETD) control connection
The ETD control must be connected to the controller with a 4 wires shielded twisted-wire pair
cable of 100 m max length. 4P4C connector is reserved for ETD.
The ETD control is IP20; it is reserved exclusively for an indoor usage sheltered from moisture.
It is equipped with an internal temperature probe.
In case of an outdoor mounting of the CADB-N unit OI, you can also leave it inside the housing of
the electrical box. Once the parameter setting is done, the remote control can be disconnected.
Placement of the support and the remote control:
ETD remote control
7.6. CONFIGURATIONS
CADB/T-N D/DI/DC PRO-REG standard confi guration
From these confi gurations there are multiple variables that can be performed by the professional
installer quickly and easily.
sensors or control valves for water coils,
2
Fixation support
46