Inserting/Changing The Saw Blade; Dust/Chip Extraction - LEMAN SSP210 Manual De Instrucciones

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

2. Electrical safety
The electric motor has been designed for one voltage only. Always check that the power supply corresponds to
the voltage on the rating plate.
This machine is double insulated in accordance with EN 60745
3. Switch status check
Ensure that the power switch is in the OFF position. If the plug is connected to a power receptacle while the
power switch is in the ON position, the power tool will start operating immediately, which could cause a serious
accident.
4. Extension cord
When the work area is removed from the power source, use an extension cord of sufficient thickness and rated
capacity. The extension cord should be kept as short as practicable.
NOTE: Before using the tool, read the instruction book carefully.
Prior to assembly and adjustment always unplug the tool.
When mounting the saw blade, wear protective gloves; danger of injury when touching the saw blade.
When changing the saw blade, take care that the saw blade holder is free of material residue, e. g.
wood or metal shavings.
1. Inserting the Saw Blade
- Turn the locking sleeve (3) approx. 90° in the direction of the arrow and hold (Fig 4).
- Push the saw blade (1) into the saw blade holder.
- Release the locking sleeve (3).
CAUTION:
- Check the tight seating of the saw blade.
- Loose saw blade can fall out and lead to injuries.
2. Removing the Saw Blade
- Turn the locking sleeve (3) approx. 90°in the direction of the arrow and hold (Fig 4).
- Remove the saw blade (1).
1. Dusts from materials such as lead-containing coatings, some wood types, minerals and metal can be harmful to
one's health. Touching or breathing-in the dusts can cause allergic reactions and/or lead to respiratory infections of
the user or bystanders.
2. Certain dusts, such as oak or beech dust, are considered as carcinogenic, especially in connection with wood-
treatment additives (chromate, wood preservative).
3. Materials containing asbestos may only be worked by specialists.
4. Prevent dust accumulation at the workplace; dusts can easily ignite.
- Provide for good ventilation of the working place.
- It is recommended to wear a P2 filter-class respirator.
5. Observe the relevant regulations in your country for the materials to be worked.
CAUTION:
- To prevent accidents, make sure to turn the switch off and disconnect the plug from the receptacle when the drill
bits and other various parts are installed or removed. The power switch should also be turned off during a work
break and after work.
- Always observe the safety instructions and applicable regulations.
- Observe correct mains voltage! The voltage of the power source must agree with the voltage specified on the
nameplate of the machine.
GB

INSERTING/CHANGING THE SAW BLADE

DUST/CHIP EXTRACTION

OPERATION
; therefore no earth wire is required.
18

Publicidad

Tabla de contenido
loading

Tabla de contenido