Transport And Stocking; Placing The Machine On The Floor; Installationg - LEMAN RAD310-RAD310T Manual De Instrucciones

TRANSPORT AND STOCKING

During the transport and stocking it is necessary to protect the machine from excessive
vibrations and excessive humidity. The machine can be stocked under the roof with air
0 0
temperature from –25 C to 55 C.

PLACING THE MACHINE ON THE FLOOR

Remove the metal sheet clamping.
Remove the attachments fixing the machine to the crate (screws and bolts)
Clear a sufficient large area round the machine.
Raise the machine slightly and fit two planks under the feet. Use planks which are long enough
to act as ramps down to the floor. Pull the machine making sure that it stays on the planks.
Once the machine is clear of the crate it will tip.
INSTALLATION
To guarantee corrected alignment of the working surfaces and prepare a stable, level,
concrete floor.
WARNING! When handling, take care to avoid shocks or large forces which could cause
damage or put the machine out of adjustment.
４
EN