Stihl RE 362 Manual De Instrucciones página 40

Ocultar thumbs Ver también para RE 362:
Tabla de contenido

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 103
English
Only connect the high-pressure cleaner
to the drinking water main in conjunction
with a back flow preventer – see "Special
accessories".
WARNING
If drinking water has passed
through the back flow preventer, it
can no longer be regarded as
drinking water.
Do not use the machine with dirty water.
If there is a risk that dirty water will occur
(e. g., flowing sand), an appropriate
water filter must be used.
Inspect the high-pressure cleaner
WARNING
The high-pressure cleaner should
only be used if it is in full working
order and undamaged – risk of
accident!
It must be possible to move the
switch to the 0 position easily
The switch must be in the 0 position
Do not use the machine with a
damaged high-pressure hose,
spray attachment and safety
devices
High-pressure hose and spray
attachment in good condition
(clean, moving easily) and correctly
assembled
For good control of the machine, the
handles should be clean and dry
with no oil or dirt on them
Check oil level
38
Never attempt to modify the controls
or safety devices in any way
Set up the machine so that it cannot
slip or tip over. Only operate the
machine on a stable and level
ground
Electrical connection
WARNING
Minimize the risk of electrical shock:
Voltage and frequency of the
machine (see rating plate) must
match the voltage and frequency of
the mains supply
Examine the connecting cord,
power plug and extension cord for
damage. Do not use the machine
with a damaged connecting cord,
extension cord or damaged power
plug
Only connect the machine to a
correctly installed power socket
The insulation on the connecting
cord and any extension cord, the
plug and the coupling must be fully
intact
Never touch the power plug,
connecting cord and extension
cord, and electrical plug
connections with wet hands
WARNING
Route the connecting cord and
extension cord properly:
Observe the minimum cross-section
of the individual cords – see
"Connecting the machine to the
power supply"
Route and mark the power cord so
that it cannot become damaged and
no one is endangered – risk of
stumbling!
Use of unsuitable extension cords
can be dangerous. Use only
extension cords that are approved
for outdoor use and are
correspondingly marked and have a
sufficient cross-section
The connector and coupling of the
extension cord must be waterproof
and must not lie in water
It is advisable to keep the plug
connection at least 60 mm above
the ground/floor, e. g. by using a
cable reel
Don't let the cord rub against edges
or pointed or sharp objects
Don't squeeze the cord under doors
or windows
If cords become snarled – unplug
the power plug and unsnarl the cord
Always unroll the power cord from
the cable reel completely, to avoid
risk of fire due to overheating.
RE 362, RE 362 PLUS, RE 462, RE 462 PLUS

Publicidad

Tabla de contenido
loading

Este manual también es adecuado para:

Re 462

Tabla de contenido